Home Wetsuit Information Wetsuit Repair

flash system instruction tag

GIGA #40 Technology Used
by Aquaman Triathlon Wetsuit

gig_tech_ad.jpg

Online Store

Show Cart
Your Cart is currently empty.


Wetsuit Repair
STEP ONE
Cut in your wetsuit is most commonly done by finger nails or a sharp object when the neoprene is stretched.		 wr1
STEP TWO
Hold the cut open as much as possible so that the glue can get deep inside the cut.		 wr2
STEP THREE
Using a toothpick or q-tip put some glue inside the cut. Be sure to put glue all over both edges with not too much excess glue.		 wr3
STEP FOUR
Let glue sit in the cut with the cut open for about 4 minutes.  This allows the air to activate the glue.		 wr4
STEP FIVE
After the glue has had time to bond while sitting open, firmly press down with your finger to ensure the two pieces match up.		 wr5
STEP SIX
The end product will look similar to the picture above.  The suit will be left with only a small scar.		 wr6

Here are just a few examples of the rubber glue/adhesive
that can be found at any good hardware store.

glue